HF ELX 50 Refill
Reduces chlorine, taste and odors · Suspended Particle Retention in Water
Triple filtration filter element with activated carbon (HPC). Reduces chlorine and retains sediments. Compatible with Electrolux purifiers PE12A, PE12B, PE12G and PE12V. Flow rate of 50 l/h.
- Max. flow rate
- 50 L/h
- Refill service life
- 5,000 L
- ≥ 5 a < 15 µm
- Classe C
- Sediment Retention
- Chlorine Reduction
- Reduction of tastes and odors
Our sales team responds within 24 business hours.
Overview
About this product
The HF ELX 50 Refill is the filter element from the MultiUso Line intended for replacement in Electrolux purifiers, with triple filtration and high efficiency in chlorine reduction.
The first layer, made of non-toxic polypropylene (Melt Blown process), retains dirt such as sand, mud and silt. Next, water passes through a bed of granulated activated carbon, responsible for chlorine reduction through HPC technology. Finally, in the clarification stage, a new polypropylene barrier prevents the passage of small carbon residues.
Main benefits:
- Triple filtration, with sediment retention and chlorine reduction
- Minimum reduction of 75% of free chlorine until the end of service life
- HPC technology, with non-toxic granulated activated carbon
- Flow rate of 50 l/h
- Disposable filter element, no need for backwashing
- Compatible with Electrolux purifiers PE12A, PE12B, PE12G and PE12V
Usage recommendation: in case of premature element saturation, installation of a pre-filter is recommended. The product is intended for water filtration that meets the potability parameters of the Ministry of Health.
Complies with NBR 16098:2012 standard.
Technical sheet
Technical specifications
Performance
- Max flow rate (L/h)
- 50 L/h
- Service life (liters)
- 5,000 L
- Service life (months)
- 6 months
- Filtration class
- Classe C (≥ 5 a < 15 µm)
- Efficiency
- Sediment Retention · Chlorine Reduction · Reduction of tastes and odors
Operating conditions
- Water temperature
- 5 °C to 50 °C
- Working pressure
- 19.6 kPa to 392 kPa
- Installation position
- Vertical
Dimensions
- Height
- 27 cm
- Width
- 6,6 cm
- Depth
- 6,6 cm
Materials and refill
- Composition
- Polypropylene and granulated activated carbon
Standards and certificates
- Standards and certifications
- NBR
Installation
Step by step
Connections
- Installation position
- Vertical
- Inlet connection
- Snap-fit
- Outlet connection
- Snap-fit
In the box
- 1 HF ELX 50 Refill
- Close the water shut-off valve that feeds the purifier.
- Unplug the purifier from the outlet.
- Access the compartment where the refill is located.
- Turn the saturated refill counterclockwise to remove it.
- Insert the new refill by turning clockwise until the guide pins snap into place, then turn 1/4 turn until it locks.
- Make sure the refill is properly installed.
- Open the shut-off valve and plug the purifier back in.
- Press the reset button for 5 seconds (or until the change light flashes).
- Close the lid and discard the first liters to remove excess carbon.
HF ELX 50 Refill
SKU 903-0580