HF40 Short Thread Refill
Suspended Particle Retention in Water · Reduces chlorine, taste and odors
Filter element with activated carbon that reduces chlorine, sediment, taste and odor from water. Triple filtration, disposable and no backwash required. Recommended for mobile spout filters.
- Max. flow rate
- 20 L/h
- Refill service life
- 1,000 L
- ≥ 15 a < 30 µm
- Classe D
- Sediment Retention
- Chlorine Reduction
Our sales team responds within 24 business hours.
Overview
About this product
The HF40 Short Thread Refill is the filtering element indicated for those seeking water with pleasant taste and odor, combining filtration efficiency with an accessible cost. Developed for mobile spout filters, it delivers higher quality to water consumed daily.
Its differentiator lies in triple filtration: the first layer of non-toxic polypropylene retains dirt such as sand, clay and silt; then, water passes through a bed of activated carbon, responsible for free chlorine reduction; finally, a new polypropylene barrier prevents the passage of carbon residues, ensuring clean and crystal-clear water.
Main benefits:
- Reduces free chlorine, unpleasant tastes and odors from water
- Non-toxic and natural activated carbon, for complete filtration
- Disposable filtering element, no need for backwashing
- Filtration grade of 15 microns (much smaller than a grain of sand, between 200 and 500 microns)
- 1/4" BSP thread, compatible with POP One Purifier and POP Tap
Usage recommendation: when installing for the first time, allow approximately 20 liters of water to flow to release the natural powder from the carbon and obtain crystal-clear water from the start.
Complies with Portaria PRC MS nº 5/2017 from the Ministry of Health and NBR 16098:2012 standard.
Technical sheet
Technical specifications
Performance
- Max flow rate (L/h)
- 20 L/h
- Service life (liters)
- 1,000 L
- Service life (months)
- 6 months
- Filtration class
- Classe D (≥ 15 a < 30 µm)
- Bacteriological filtration
- No
- Efficiency
- Sediment Retention · Chlorine Reduction
Operating conditions
- Water temperature
- 5 °C to 50 °C
- Working pressure
- 19.6 kPa to 392 kPa
- Installation position
- Vertical
Dimensions
- Height
- 13.6 cm
- Width
- 5,4 cm
- Depth
- 5,4 cm
Materials and refill
- Composition
- Polypropylene and granulated activated carbon
- Washable refill
- No
Standards and certificates
- Standards and certifications
- NBR
Installation
Step by step
Connections
- Installation position
- Vertical
In the box
- 1 HF 40 Refill
- 1st Close the purifier tap. Unscrew the cap to remove the filter element that is attached to it. You can also remove the cup to clean it.
- 2nd Replace the filter element by screwing it onto the cup cap. Make sure the new element is properly screwed onto the cap.
- 3rd Check the seal of your filter before opening the tap. In case of leaks, check the tightness of the cup and cap.
- Attention: discard the first 10 liters of water until the water becomes crystal clear so that the refill releases the carbon powder.
HF40 Short Thread Refill
SKU 904-0005