









Countertop Tap w/ POP Purifier White
Reduces chlorine, taste and odors · Activated Carbon · Water Purifier · Natural Water
Complete tap and purifier system, ready for countertop installation. Reduces chlorine, dirt and bad taste from water with triple filtration. Includes extra refill.
- Max. flow rate
- 20 L/h
- Refill service life
- 1,000 L
- Chlorine reduction
- 75%
- ≥ 15 a < 30 µm
- Classe D
- Sediment Retention
- Chlorine Reduction
Our sales team responds within 24 business hours.
HF40 Short Thread Refill
Official replacement refill for this product.
Overview
About this product
The POP White Countertop Tap with Purifier is the complete solution for those who want filtered water straight from the tap, with simple and practical countertop installation. The system comes ready, combining tap and filter in a single product.
Its screw-in activated carbon filter element reduces the chlorine present in the water, as well as the unpleasant smell and taste it causes in excess. Filtration happens in three stages: first, water passes through a polypropylene barrier (Melt Blown) that retains suspended dirt; then, it passes through an internal activated carbon chamber, responsible for dechlorination; and finally, it passes through a new layer of polypropylene for final clarification, delivering cleaner water with pleasant taste.
Key benefits:
- Disposable filter element, no backwashing required
- Minimum 75% reduction of free chlorine
- Particle Retention Class D
- Flow rate of 20 l/h
- Recommended for countertop installations
- Available in white (code 907-2364) and black (code 907-2366)
Usage recommendation: to ensure water quality, replacement of the filter element is recommended every 1,000 liters, 4 months, or when a reduction in water flow is observed.
Complies with Ministry of Health Ordinance PRC MS nº 5/2017 and standard NBR 16098:2012.
Technical sheet
Technical specifications
Performance
- Max flow rate (L/h)
- 20 L/h
- Service life (liters)
- 1,000 L
- Service life (months)
- 6 months
- Filtration class
- Classe D (≥ 15 a < 30 µm)
- Chlorine reduction (%)
- 75 %
- Bacteriological filtration
- No
- Efficiency
- Sediment Retention · Chlorine Reduction
Operating conditions
- Water temperature
- 5 °C to 50 °C
- Working pressure
- 19.6 kPa to 392 kPa
- Installation position
- Vertical
Dimensions
- Height
- 29 cm
- Width
- 21,5 cm
- Depth
- 7,5 cm
Materials and refill
- Composition
- Polypropylene and granulated activated charcoal
- Washable refill
- No
Standards and certificates
- Standards and certifications
- NBR 16098:2012 · INMETRO · ABRAFIPA
Installation
Step by step
Connections
- Installation position
- Vertical
- Inlet connection
- 3/4" threaded connection
In the box
- 1 Tap with Purifier
- 2 HF 40 Refills
- 1st Close the main shut-off valve. At the location where the filter will be installed: remove the existing tap.
- 2nd Check all connections and clean the piping before installation.
- 3rd Remove the tightening nut from the base of your filter tap for installation.
- 4th Position the tap with purifier at the installation location and thread the tightening nut underneath the countertop. (Note: if you do not have space to rotate the entire assembly, unscrew the tap and thread only the base onto the countertop.)
- 5th Connect the water inlet connection to the filter base. If necessary, use only thread seal tape for the connection.
- 6th Discard the first 10 liters of water in order to remove excess charcoal dust.
- 7th Your purifier is ready to use!
- Note: Routinely clean the cup and filter lid. Use only water and biodegradable soap. Avoid abrasive materials.
Maintenance
How to replace the refill
-
Step 01
Close the purifier tap. Unscrew the lid to remove the filter element that is attached to it. You can also remove the cup to clean it.
-
Step 02
Replace the filter element by screwing it into the cup lid. Make sure the new element is properly threaded onto the lid.
-
Step 03
Check the seal of your filter before opening the tap. In case of leaks, check the tightness of the cup and lid.
-
Step 04
Warning: discard the first 10 liters of water until the water becomes clear so that the refill releases the charcoal dust.